We recommend someone over the age of 16 or have adult supervision when applying the Big Wigz to the club.

BE AWARE: If your club has loose or chipped paint, the adhesive could remove some of that loose or chipped paint.

Tools Needed

• Damp and Dry Cloth
• Blow Dryer and/or Plastic Card (Be careful when touching the Big Wigz skin after using the Blow Dryer. It could be extremely hot.)
• Sharp Scissors

Quick Prep Steps and Tips

• Read over the entire Big Wigz Skins Instructions before applying it to the club head and take your time.
• Wipe the club with a damp cloth and let it dry completely before applying the Big Wigz Skin above the metal wood to get a visual of how it will sit.
• It is recommended to have a blow dryer when applying the Big Wigz Skin. Use the blow dryer on the adhesive side for 10 seconds or until the skin is warm and then continue with the application process. The heat will make the skin easier to apply and secure its location. Once the trimming process is complete and the edges are pressed down, use the blow dryer until the skin is warm and press again around the edges for total security.
• It is important when you are pulling the skin towards a particular side you are at the same time using your thumb as a combing agent to secure a clean and wrinkle free application.(Reference Picture Number 2)
• Peel the Big Wigz Skin from the backing paper, exposing the adhesive. Be sure to not allow the Big Wig adhesive sides to stick to each other. It could possibly damage or impair the Big Wigz Skin.
• When applying to clubs with ridges or dips press the skin close to the deepest part of the ridge or dip and secure its position. Watch for air pockets around these areas. The blow dryer is helpful with these areas to really get the skin loose.

Applying (3-5 minutes to apply)

• First step is to align the skin close to the base of the shaft and directly above the hitting surface. Secure the front half of the shaft cut out around the base of the shaft by pressing the Big Wigz logo firmly to the club.

• Then pull the skin towards the toe of the club aligning it along but above the hitting surface of the club. In one motion when you are pulling the skin use your thumb as a combing agent to secure the skin wrinkle free (Try to have none of the club's paint exposed but do not have the skin on the hitting surface). If the Big Wigz Skin does not line up, peel it back and try to reapply. Be careful when peeling it back.

• Next firmly pull the Big Wigz Skin toward and over the back end of the club. Be sure to use your thumb as a combing agent(thumb is dragging behind securing the skins position wrinkle free) when pulling the skin.It is important to pull it tight over the entire club and be sure that there are no wrinkles when you are securing its location. (There will be an excess amount hanging over the club).

• Once the Big Wigz Skin is pulled tightly over the club, and there are no wrinkles present, press down from the center to both sides. Move toward the back of the club head once the material is evenly pressed down from side to side and smooth. When you are pressing down make sure there are no wrinkles present. Pull the skin up at anytime to remove any wrinkles.

• There should be an excess amount hanging over the club, use scissors to closely trim off the excess material around the curved edge of the club. Start at the back end of the shaft and work your way around the club to the toe. Get as close to the club as you can and try to cut on the same straight path. (It is very important when you are trimming the skin, that the skin is trimmed to just hang over the curvature part of the club. If it is trimmed to sit above the curvature it will be more susceptible to wrinkles.) BE CAREFUL TO NOT COME IN CONTACT WITH THE CLUB WHEN TRIMMING.

• When the trimming process is complete and the Big Wigz Skin is applied; use a blow dryer over the entire Big Wigz Skin, especially on the edges.

• After using the blow dryer and the Big Wigz Skin is not hot, we suggest you then use your thumb and firmly press down on all of the edges to secure the Big Wigz skin position. (If you do not have access to a blow dryer, use at least a plastic card to secure the edges.)